一类广义Lanchester模型的数值解及若干结论

本讨论了一类广义的Lanchester模型在一些限制条件下的近似解，并给出了若干结论。     

Nonlinear rheological behavior of silica filled solution‐polymerized styrene butadiene rubber

The reinforcement and nonlinear viscoelastic behavior have been investigated for silica (SiO₂) filled solution‐polymerized styrene butadiene rubber (SSBR). Experimental results reveal that the nonlinear viscoelastic behavior of the filled rubber is similar to that of unfilled SSBR, which is inconsistent with the general concept that this characteristic comes from the breakdown and reformation of the filler network. It is interesting that the curves of either dynamic storage modulus (G′) or loss tangent (tan δ) versus strain amplitude (γ) for the filled rubber can be superposed, respectively, on those for the unfilled one, suggesting that the primary mechanism for the Payne effect is mainly involved in the nature of the entanglement network in rubbery matrix. It is believed there exists a cooperation between the breakdown and reformation of the filler network and the molecular disentanglement, resulting in enhancing the Payne effect and improving the mechanical hysteresis at high strain amplitudes. Moreover, the vertical and the horizontal shift factors for constructing the master curves could be well understood on the basis of the reinforcement factor f(φ) and the strain amplification factor A(φ), respectively. The surface modification of SiO₂ causes a decrease in f(φ), which is ascribed to weakeness of the filler–filler interaction and improvement of the filler dispersion. However, the surface nature of SiO₂ hardly affects A(φ). © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 2594‐2602, 2007     

Preparation of dye-loaded SiO2 nanoparticles

A room temperature method for the encapsulation of pyrene in SiO₂ nanoparticles is described. The relation between alkoxysilane surfactant chain length, reactant molar ratios and the uptake of dye, sample morphology, photophysical properties, and the ability of the silicate matrix to protect the encapsulated dye was examined. The synthesis can easily be adapted for the encapsulation of other hydrophobic and thermolabile substances, and used in the development of nanostructured optically active coatings, films and monoliths.     

Synthesis of poly(ethylene oxide) with pending 2,2,6,6‐tetramethylpiperidine‐1‐oxyl groups and its further initiation of the grafting polymerization of styrene

A new stratagem for the synthesis of amphiphilic graft copolymers of hydrophilic poly(ethylene oxide) as the main chain and hydrophobic polystyrene as the side chains is suggested. A poly(ethylene oxide) with pending 2,2,6,6‐tetramethylpiperidine‐1‐oxyls [poly(4‐glycidyloxy‐2,2,6,6‐tetramethylpiperidine‐1‐oxyl‐co‐ethylene oxide)] was first prepared by the anionic ring‐opening copolymerization of ethylene oxide and 4‐glycidyloxy‐2,2,6,6‐tetramethylpiperidine‐1‐oxyl, and then the graft copolymerization of styrene was completed with benzoyl peroxide as the initiator in the presence of poly(4‐glycidyloxy‐2,2,6,6‐tetramethylpiperidine‐1‐oxyl‐co‐ethylene oxide). The polymerization of styrene was under control, and comblike, amphiphilic poly(ethylene oxide)‐g‐polystyrene was obtained. The copolymer and its intermediates were characterized with size exclusion chromatography, ¹H NMR, and electron spin resonance in detail. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 3836–3842, 2006     

对地观测平台恒星敏感器离焦成像折中设计分析

从对地观测平台角秒量级姿态确定需求出发,在构建星敏感器惯性系成像模型的基础上指出,恒星在成像面上的定位误差是星敏感器姿态确定误差的主要来源。同时,结合理想光学系统离焦模型,分析了星敏感器主要性能指标间的量化关系,并给出了成像面定位误差最低限。仿真结果表明,从优化系统性能考虑,成像模糊区直径为2~3个像元的配置是利用星敏感器焦平面的“轻微离焦”来实现亚像元定位的最佳方案,定位误差可达0.2个像元,能够满足星敏感器惯性姿态确定精度4″~5″的要求。理论分析和数值仿真结果可为后续星敏感器指标的提出及仪器设计提供技术参考。     

双层散射介质的单次后向散射光谱分析

从上皮组织的结构特点出发,基于米氏(Mie)散射理论,建立了双层散射介质的单次后向散射光谱的理论模型,该模型通过偏振门屏蔽来自下层的噪声背景,只保留来自上层的单次散射光。计算分析了粒子的形态学参量如平均尺寸及其分布、相对折射率变化时,单次散射光谱的特征。并用傅里叶波形分析法研究了这些参量对单次后向散射光谱曲线形状及其谐波幅值的影响。结果表明,这些只经历了表层粒子单次散射的光谱信号对表层粒子的平均尺寸及其分布、相对折射率具有灵敏性。对光谱曲线波纹结构的幅值、频率,散射强度,光谱谐波的幅值有直接的影响。研究结果对早期癌症的散射光谱特征识别及其特征提取有重要的实用价值。     

一步法合成苯乙烯催化剂表面积炭对活性的影响

应用ＥＳＲ，空气气氛下ＤＴＡ，氢气氛下ＴＰＳＲ，ＩＲ等技术手段，对反应后催化剂的积炭行为进行了研究。结果表明，反应后的催化剂表面不同程度地存在着不同类型和积炭，积炭是催化剂失活的主要原因。     

纳米碳管修饰铂结合溶胶-凝胶固定酶制备高性能胆碱生物传感器

为了提高胆碱传感器的灵敏度和抗干扰性,以纳米碳管修饰铂电极为基础电极,采用溶胶-凝胶法固定胆碱氧化酶(ChOx),构建了电流型胆碱检测生物传感器,对纳米碳管修饰电极的电化学特征进行分析,得知纳米碳管的引入不仅使电极对H2O2的催化电流增大,同时降低了电催化所需的恒定电位。讨论了缓冲液介质、pH值、酶负载量对传感器响应的影响。研究表明,所制备的传感器在pH 7.2、电位为0.15V条件下对氯化胆碱的线性响应范围为5.0×10-6~1.0×10-4mol/L;检出限为5.0×10-7mol/L;灵敏度为9.48μA/mmol/L。传感器的稳定性好,经过1个月,仍可保持初始电流的85%。抗干扰能力有很大提高。用于人体血清中的胆碱浓度测定,结果令人满意。     

Studies on the Structure and Properties of Cordierite Synthesized by Talc-Magnesite

Homogeneous cordierite has been synthesized at low cost by talc-magnesite and coal gangue as the main raw materials. The mechanism of synthesizing cordierite under such a com- posing system of raw materials, and the effect of temperature on the crystal cell parameters and microstructure and thermal expansion coefficient of cordierite crystal have been studied via testing methods of XRD, SEM, etc. The result shows that the homogeneous cordierite can be synthesized by the systematic composing materials of “talc-magnesite—coal gangue—talc” with heat pre- servation at 1350 ℃ for 1 h; as the keeping time is prolonged, Al3+ and Mg2+ in cordierite crystal are replaced by a few impurity ions such as Fe3+, Fe2+, etc., and the crystal cell parameters of cordierite present an increase trend; as the high-temperature heat preservation is prolonged, the content of glassy phase in the sample is increased, its density is improved, and its thermal expansion coeffi- cient presents an increase trend.     

A Novel Organic—Inorganic Complex：Synthesis and Crystal Structure of [Ca（DMSO）5（H2O）]2 SiMo12O40

It is becoming a focus to synthesize and assemble organic-inorganic materials, especially, to synthesize charge-transfer complexes formed by polyoxometalate and organic donors. They have attracted much attention because such complexes are active in their electric, magnetic and optic properties1-4, many investigations about them have been done and some crystal structures of them were reported5-6. But, the disadvantage of these crystals is instability at room temperature. According to the view…